Domino Sim2 Bedienungsanleitung PDF herunterladen (Seite 18)

Using the projector

Preparations

1. Plug in and turn all of the connected equipment on.

2. If not already in, plug the supplied power cable into the

AC inlet on the rear of the projector and turn on the power

switch.

3. Plug the power cable into a wall socket and turn the wall

switch on.

Turning the projector on

Follow the steps below.

1. Make sure the Power light is orange after power has been

applied and the main AC power switch is turned on.

2. Press and hold POWER () on the remote control to turn

the projector on.

3. The fans will start operating, and a start-up image displays

on the screen for a few seconds while it warms up.

4. If you are prompted for a password, press the arrow keys to

enter a six digit password. See "Utilizing the password

function" on page 20 for details.

5. "Source Searching..." will be displayed on the screen

before the projector identifies the input signal. This

message will remain on the screen until a valid signal is

detected. See "Selecting an input source" on page 18 for

details.

6. If the horizontal frequency of the input signal exceeds the range of the projector, the

message "Out of Range" will be displayed on the screen. This message will remain on-

screen until you change the input signal to an appropriate source.

Selecting an input source

The projector can be connected to multiple equipment at the

same time. When the projector is first turned on, it will attempt to

reconnect with the input source which was in use when the

projector was last shut down.

To select the video source:

• Using the remote control

Press one of the Source buttons on the remote control. To switch

between HDMI 1 and HDMI 2, press HDMI again.

•Using the OSD menu

1. Press MENU and then press / until the System menu is

highlighted.

2. Press to highlight Input Source and press ENTER. The source

selection bar displays.

3. Press / repeatedly until your desired signal is selected

and press ENTER.

Once detected, the selected source information will display

on the screen for seconds. If there is multiple equipment

connected to the projector, you can go back to the source

selection bar again to search for other signals.

• If you want the projector to automatically search for the

signals, select On in the System > Auto Source Search menu.

The projector will not

respond to further

commands while it is

warming up.

HDMI 1

Video

S-Video

Component 1

Component 2

Language

Splash Screen

My Screen

Projector Position

Auto Off

Sleep Timer

Background Color

Menu Settings

Input Source

System

S-Video

English

SIM2

Auto Source Search

EXIT Back

Disable

Blue

Floor Front

ENTER

RGB HD

HDMI 2

NOTE: When

automatically

searching for an

valid input source,

the projector cycles

through the

available signals

following the

sequence from top

to bottom as the

source selection

bar shows.

Display

Setup

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 51 52

Kommentare zu diesen Handbüchern

Keine Kommentare

Domino Sim2 Bedienungsanleitung Seite 18

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Projektoren Domino Sim2