Domino Sim2 Bedienungsanleitung PDF herunterladen (Seite 47)

47

Additional information

Troubleshooting

Problem Cause Remedy

The projector does

not turn on.

There is no power from the

power cable.

Plug the power cable into the AC inlet

on the rear of the projector, and plug

the power cable into to the power

outlet. If the power outlet has a

switch, make sure that it is switched

on. (See page 18)

The power switch is not in the

on position.

Put the power switch in the on

position. (See page 18)

Attempting to turn the

projector on again during the

cooling process.

Wait until the cooling down process

has completed.

The lamp cover is not securely

attached.

Correctly attach the lamp cover. (See

page 44)

No picture.

The video source is not turned

on or connected correctly.

Turn the video source on and check

that the signal cable is connected

correctly. (See page 15)

The projector is not correctly

connected to the input source

device.

Check the connection. (See page 15)

The input signal has not been

correctly selected.

Select the correct input signal with the

Source buttons on the remote control.

(See page 18)

Image is unstable.

The connection cables are not

securely connected to the

projector or the signal source.

Correctly connect the cables to the

appropriate terminals. (See page 15)

Picture is blurred.

The projection lens is not

correctly focused.

Adjust the focus of the lens using the

focus ring. (See page 19)

The projector and the screen

are not aligned properly.

Adjust the projection angle and

direction as well as the height of this

unit if necessary. (See page 22)

Remote control

does not work

correctly

The batteries are out of power.

Replace both of the batteries with

new ones. (See page 5)

There is an obstacle between

the remote control and the

projector.

Remove the obstacle. (See page 5)

You are too far away from the

projector.

Stand within 8 meters (26.2 feet) of the

projector. (See page 5)

1 2 ... 42 43 44 45 46 47 48 49 50 51 52

Kommentare zu diesen Handbüchern

Keine Kommentare