Domino Sim2 Bedienungsanleitung PDF herunterladen (Seite 41)

Additional information

Care of the projector

Your projector needs little maintenance. The only thing you have to do on a regular basis is

keep the lens clean and clean or replace the air filter. Never remove any parts of the

projector except the lamp or the air filter. Contact your dealer or local service centre if the

projector fails to operate as expected.

Cleaning the lens

Clean the lens whenever you notice dirt or dust on the surface. Before you attempt to clean

the lens, turn the projector off, unplug the power cable, and leave it several minutes to cool

completely.

1. Use a canister of compressed air to remove dust. (Available from building hardware or

photographic suppliers.)

2. If there is stubborn dirt or smudge marks, use a proper photographic lens brush or

moisten a clean soft lens cloth with lens cleaner to gently wipe the lens surface.

Never touch the lens with your finger or rub the lens with abrasive materials. Even paper towels can

damage the lens coating. Only ever use a proper photographic lens brush, cloth, and cleaning solution.

Do not attempt to clean the lens while the projector is switched on or is still hot from previous use.

Cleaning the projector case

Before you attempt to clean the case, turn the projector off, unplug the power cable, and

leave it several minutes to cool completely.

1. To remove dirt or dust, wipe the case with a soft, dry, lint-free cloth.

2. To remove stubborn dirt or stains, moisten a soft cloth with water and a neutral

detergent. Then wipe the case.

Never use wax, alcohol, benzene, thinner or other chemical detergents. These can damage the case.

Storing the projector

If you need to store the projector for an extended time, please:

1. Make sure the temperature and humidity of the storage area are within the

recommended range for the projector. Please refer to the Spec. page in this manual or

consult your dealer about the range.

2. Retract the adjuster feet.

3. Remove the batteries from the remote control.

4. Pack the projector in its original packing or equivalent.

Transporting the projector

It is recommended that you ship the projector with its original packing or equivalent. When

you carry the projector yourself, please use a soft carry case.

Cleaning and replacing the dust filter

The message to the right displays periodically every

500 hours use. You can also use the Setup > Dust Filter

> Dust Filter Hours menu or the Information > Dust

Filter Hours menu to check how long the filter has

been used. If the filter is not cleaned, it can become

clogged with dust and prevent proper ventilation.

This can cause overheating and a malfunction of the

projector. Should the projector filter become seriously

clogged with dust, it can cause over-heating inside

of the projector.

WARNING

Please check if the filter is clean.

Clean the filter or replace

with a new one.

FILTER CLEAN REMIND NOTICE

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 51 52

Kommentare zu diesen Handbüchern

Keine Kommentare

Domino Sim2 Bedienungsanleitung Seite 41

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Projektoren Domino Sim2